產品特性

1、屏幕顯示內容：無線高壓核相儀，不同相、同相、頻率、X、Y、 、 、。

2、電源：主機采用可充電電源，X和Y***器 采用5節AG10電池。

3、自動關機：開機后8分鐘左右主機會自動關機 。

4、接觸被測強電場時，儀器會自動報警。

產品參數

①準確度：同相誤差≤15°，不同相誤差≤15°

②采樣速率 3次/秒

③X和Y***器電源電壓為7.5V±1.5V

④X和Y***器工作電流≤5mA

⑤主機和 X、Y***器的視距傳輸距離為X、Y≥20m

⑥工作環境：0℃┉+50℃濕度：≤85%RH

⑦儲存環境：0℃┉+55℃濕度：≤85%RH

⑧本產品所測電壓等級為 0.38KV┉220KV

?

安全事項

1、現場測試時，操作人員應按電力部門高壓測試安全距離標準進行操作。

2、所測試絕緣桿電壓等級為 ≤220KV。

3、（特別注意：每次使用前請認真檢查絕緣桿的絕緣性能，注意天氣情況，嚴格遵守國家高壓試驗的相關規定！）

4、使用時應認真執行本單位安全規章制度，并嚴格遵守DL408-91安全工作規程（發電廠變電所電氣部份）相關規定，仔細保管儀器，定期檢查絕緣。

5、絕緣桿為6節伸縮式，在使用時，不管工作電壓是否為**電壓，均要把伸縮絕緣桿拉到最長狀態（約3.2米），握手時只能握在第六節上，不得在第五節上握手。

?

Product introduction

NAWT?Wireless High-voltage Phasing Tester , used in power lines , substations and phase sequence phase check verification , with nuclear phase , phase sequence ,electricalinspection and other functions with a strong anti-interference, compliance (EMC ) standards, adapt to various electromagnetic interference occasions . High voltage phase signal will bemeasured bythe collector out emitted directly after the treatment . Received by the nuclear phase and the phase comparison , the results for the nuclear phase characterization. BecauseNAWT?Wirelesshigh-pressure nuclear phase meter is a wireless transmission , thereby achieving safe, reliable, fast and accurate , adapt to various nuclear phase occasion.

Also called?name

Nuclear phase meter , nuclear phase devices, wireless nuclear phase device, high-voltage nuclear phase device, high-voltage nuclear phase meter , voice nuclear phasedevice,wireless nuclear phase device

The Characteristics of the products

1.NAWT?Wireless High-voltage Phasing Tester adopting large-capacity and maintenance-free battery, which completely solve the disposable electricity shortage andtroublesomereplacement for carbon battery, button batteries and other disposable battery, especially suitable for field work ; without loading the battery, so it do not cause spark , therefore thedevicecomplies with safety ?mining equipment safety designing.

2.In the long-distance testing, the visible range will up to 200m, and can be used through the walls.

3.The phase, waveform, and frequency date will be showed on the LCD screen, the testing is quite safe,fast and reliable, with real female voice broadcasting.

4.Adopting the telescopic insulating rod , is portable and easy to use, the insulation performance meet requirements of electric insulation withstand testing.

5.The portable receiver with elegant design and non-slip treatment process

6.The total device adopts advanced technology, small and light.

The parameters of the products

① Accuracy: phase error≤15°, different phase error≤15°

② Sampling rate 3 times / sec

③ X and Y collector supply voltage is 7.5V±1.5V

④ X and Y collector current≤5mA

⑤ host and X, Y acquisition the sight transmission distance of X, Y≥20m

⑥ working environment : 0° ┉+50°humidity :≤85% RH

⑦ storage environment : 0° ┉+55°humidity :≤85% RH

⑧ the product of the measured voltage level of 0.38 KV┉220KV

?

Power supply: AC110V/115V/120V/127V/220V/230V/240V,?can optional

Input frequency: 50Hz/60Hz optional

Note: Our users can select the corresponding power which based on their local supply voltage and frequency, and we will confirm it before the delivery (or inform us that thegoodswill be used in which country advance)

?